Our AL619 can trip the check engine light on? I don't know it has this function. ... Well, U0155 = lost communication with IPC control module.....U110C is a chrysler code. NO FUEL LEVEL BUS MESSAGE. When Monitored and Set Condition: U110C-NO FUEL LEVEL BUS MESSAGE When Monitored: Ignition on. Set Condition: No fuel level BUS messages received by the PCM for 20 seconds. POSSIBLE CAUSES DTC RESET COMMUNICATE WITH BCM FUEL LEVEL BUS MESSAGE PCI BUS CIRCUIT OPEN FROM PCM TO BCM BCM TEST ACTION APPLICABILITY 1 NOTE: If a fuel level circuit or performance DTC is set along with P1681, diagnose the circuit/performance DTC before continuing. Turn the ignition on. With the DRBIIIt, erase DTCs. Start the engine on and off several times. Leave the engine running for at least 20 second each time. With the DRBIIIt, read DTCs. Does the DTC reset? All Yes ! Go To 2 No ! Refer to the INTERMITTENT CONDITION symptom in the Driveability category. Perform POWERTRAIN VERIFICATION TEST VER - 1 - NGC. 2 Ignition on, engine not running. With the DRBIIIt, attempt to communicate with the BCM. Can communication be established with the BCM? All Yes ! Go To 3 No ! Refer to the Communication Category and perform the appropriate symptom related to no communication with BCM. Perform POWERTRAIN VERIFICATION TEST VER - 1 - NGC. 3 Turn the ignition on. Using the DRBIIIt, read the Fuel Level parameter in the PCM. Does the DRBIIIt display a fuel level value? All Yes ! Replace and program the Powertrain Control Module in accordance with the Service Information. Perform POWERTRAIN VERIFICATION TEST VER - 1 - NGC. No ! Go To 4 287 DRIVEABILITY - NGC TEST ACTION APPLICABILITY 4 Turn the ignition off. Disconnect the PCM harness connectors. Disconnect the BCM harness connector. CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMINALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS. Measure the resistance of the PCI Bus circuit from the BCM harness connector to the appropriate terminal of special tool #8815. Is the resistance below 5.0 ohms? All Yes ! Replace BCM in accordance with the Service Information. Perform POWERTRAIN VERIFICATION TEST VER - 1 - NGC. No ! Repair the PCI Bus circuit between the PCM and the BCM for an open. Perform POWERTRAIN VERIFICATION TEST VER - 1 - NGC

I have checked with pontiac 2002. AL619 can test the Supplemental Inflatable Restraint system of this vehicle, but not ABS.

Sorry, youtube is shielded in our country. Can you upload it to a network disk? Or send it to this email: support@auteltech.com

Well, I have watched this video with someone's help, but I am not sure what you wanna say to me. I only saw the instrument panel.